Foam to Leather (Tutorial)
Brown paint (lighter than your foam)
Grab some aluminum foil and crumble it into a ball. Not too tight of a ball though! The next step is almost impossible if you do.Ā
Next, un-crumple the ball. Flatten it out into one layer. Itās fine if there are a few holes.
Place it on top of your foam.
Take your iron and firmly press it on the foam and aluminum. My iron was set to 3 (polyester) but the correct temperature may be different for other irons. Just remember not to use steam! Before doing this on a large piece, be sure to experiment and figure out what the best temperature and what the best pressure is. On larger pieces, youāll have to move the aluminum around a lot. Itās not a quick process.
Now youāve got this crinkly affect on the foam. Next is painting!
Grab youāre brush, black paint, and a dish with some water. The idea is to dilute the black paint enough so that when you apply it the paint will seep into the divets the aluminum created.Ā
Once the watery paint is applied, wipe it off with a paper towel. Continue to do this for your whole piece of foam.
Now hereās an optional step (of which I havenāt done myself but Iāve known others who have):
Grab the light brown paint and, without diluting it, paint it on. Itās best to use a coarse brush in this case and to try to keep it out of the divets. Wipe some of the paint off.Ā
Remember, imperfections are always good! Uneven paint isnāt necessarily bad so just experiment with it.Ā
Hereās an example of a bracer I did with this method. The first two pictures are an example of the foam I began with and the rest show the end result. I hope this helps you guys out!
germansingergirl
gummygunk
izzy806
blakekathryn
discoholicmusic
turnnoffyourmind
pixelskylines
