Illustration, Subculture Fashion & Art

For the folks curious about templates, these are the shapes I cut from cardboard. I added a couple little pieces of cereal box cardboard as structural support in various points, like the bridge of the nose and behind the beak. Also, I ended up cutting the forehead piece a little smaller, which I marked on the paper, but I kept the template size in case you want to see how it originally looked.

It's a completely different piece of wearable art. It has a different soul. It has a different feel.

Bear's mask templates! I just want to stress that our masks are extremely low tech and budget friendly. They're made out of cardboard, hot glue, and fleece, with an elastic band in the back. I used a little sheer black fabric I had leftover from my terror bird costume for the eyes.

Fleece and felt are very forgiving fabrics and you can basically just cut a single large piece and stretch it to fit, gluing it to the cardboard one small section at a time. The fabric was the only purchase we made for these, and it was in the form of thrift store blankets.

For everyone else, the mask gets its rounded shape from a dart cut in at the top. Just cut a straight line about an inch or so, fold one side over the other, and glue it in place. If you want an even rounder shape that will sit a bit higher off of your face (not quite glasses-friendly height, but maybe more sensory-friendly for some), you can make additional darts on the sides, roughly in line with the back corner of the eyes.

The cat muzzle uses a dart at the front to create a rounded shape. (Figuring out that one was a paaaaiiiiinnnn yesterday, but I did it!) All the others, you'll want to fold the center tab down first, then fold the left and right flaps over it. Play around with how tightly you fold them over to produce slightly different shapes, and glue it once you like what you see.

When looking to attach the different pieces, you'll want to cut lots of perpendicular flaps into the attachment points (highlighted in the picture below; you'll want to fold those parts up and glue them against the mask base). Having lots of separate attachment points will allow the cardboard to flex a little more and help with stability overall.

When fleecing or felting the base, you'll want to cut a piece that is.... way bigger than you think it needs to be. My technique is to lay the fabric on top of the mask, let it drape without pulling, and give myself about one inch above the tip of the furthest projecting part -- usually the ears. Cut a rectangle and start gluing at the bridge of the snout. Glue in sections, stretching the fabric to prevent wrinkles, until the entire piece is covered.

Then, and only then, do I cut around the shape of the mask, leaving about an inch margin around the whole piece. Cut flaps all around (like you can see in the second photo Wren posted) and glue them down, stretching as you go.

The dart is just a small slit at the top of the face that can be folded over itself and glued in place to create dimension.

I thought the muzzle looked a bit too boxy and canine, so I trimmed it down and added a few pieces of thin cardboard.

It's once again Witch Hat Monday! I've made so many fanarts over the years that I probably have one to post for every episode lol The manga has endless amazing brim hat designs that inspired me to go crazy with a Van Gogh's Starry Night hat 🌟⭐✨