#miliput

I'll replace his regular power module on the back with the two barrels seen in the pictures, wich I made from boba tea straws, the little safety rings from super glue tubes and sprue goo. I've come to the conclusion that I might have some executive dysfunction so I'm actually quite happy that I managed to come so far with this thing.

I fully acknowledge sculpting any kind of epoxy clay on a cold rainy day is ill advised, but I just felt like getting Greg’s infamous costume started. Fight me!

But it took me like an hour to get the tail on the t-rex affixed to it. I had to shave off a LOT of plastic just to get it close to flush. It barely stuck on originally and had like half an inch gap between the tail and butt.

My finished King Ezekiel cosplay from The Walking Dead! Taken from Cinel Film CMV at London comic con!

These should be fully cured by the time I get home tomorrow night. Then I can start sanding things. :)

I'm not sure why white miliput is so much stickier than the black, but I don't like it. I have to wait for it to harden a bit so it's less like freshly chewed gum. Anyways, my grandfather passed away yesterday. It's hard, I miss him.

Putty Essentials Scaleriders.com #akinteractive #infinimodel #miliput #mrhobby #modeltools #hobbytools #essentials https://www.instagram.com/p/CNpuXVTDaXW/?igshid=gzog9bzvomv3

Got another staff, a few wands, a wobbly disc, what could be an ax head, and a round ball.