. ° “りょう” ⊹ . ᶥ ‹🐊›(Slow Post)

the materials your gonna need are shown in the photo but i’ll still list them off because im so kind and nice. You need clear tape to the point of where you can see clearly through it. I use packaging tape because of its durablity and stick. Hot glue gun+sticks and depending on how big your pin is your going to need quite a few glue sticks. Cardboard, which i recomend using thin cardboard from cereal boxes and such. scissors (duh). Finally a safety pin which the metal needs to be thick so it doesn’t bend

so step one is to get your image however you’ve got it (drawing/printing it out) and put very little amounts of hot glue to attach it down. i used normal scotch tape but i dont like it because its hard to cut around the image. next your just gonna cut it out

next thing your going to do is put your tape on top of it. THIS IS YHE NOST IMPORTANT STEP!!! make sure that there is a overhang/extra tape on the sides. then your going to make tiny slits in it and then fold it down on the other side.

final step is to coat the entire back in hot glue. it will take a good minute to dry fully so pop your saftey pin on the back. after that you’ve got an awesome pin! yipeee to you!