Mad Cosplay

“:♡.•♬✧ NicoUmi ✧♬•˙♡:“

By your friendly neighborhood Lowen bc she does it all the time and is taking a break 

What you’ll need:

Your fabric 

Embroidery thread

Wonder-Under

Stabilizer

If you’re using metallic thread (in place of embroidery thread):

Metallic needle

Bobbin thread (forgot to add it in the pic)

Map out your design

This tutorial was an after thought, but place tracing paper over the area where you want the applique to be and map it out!

Retrace design onto Wonder-Under

Follow Wonder-Under Instructions and using your tracing paper map, place applique in the right place

When the design is on, follow stabilizer instructions and place it to the back of the fabric

I usually use 2-3 layers

Start sewing!

I’m using metallic thread for Kongwai and my settings are:

Tension - 3

Width - 5

Length - 0

Zig-zag stitch!!!

For Length 0 I like to do two layers of embroidery thread. Heres a comparison of 1 and 2 layers

1 Layer:

2 Layers:

Hello everyone!  I’ve gotten a lot of questions about my Davesprite cosplay and below the cut I’m going to do my best to answer them.  :D  The is mostly a wing tutorial but also covers other FAQs such as makeup and where I purchased various things.