Lowly Wormish

church mouse furby x2: available

skunk furby: available

witch cat furby x2: available

coffee furby: available

flamingo furby: SOLD

kiwi furby: available

owl furby: available

graduation furby: available

valentine's furby: available

bear furby: available

pink leopard furby: available

gorilla furby: available

springtime furby: available

tiger furby: available

rare japanese furby knock-off "poopi": available ($80)

Hello to make this jacket you’ll need scissors, a sewing machine, sewing needle, thread, a zipper, drawstring elastic measuring tape, a marker, paper, and three fabrics(I picked two cottons and a kinky fabric for the fur but feel free to use any kind)

I’ll be referring to my fabrics as 1, 2, and 3

We’ll start by drawing and cutting out our pattern, pattern piece one is 3.5 inches wide and 3 inches tall, piece two is 7 inches wide and 3 inches tall, and piece 3 is is 14 inches wide and in the middle at 7 inches it’s 6 inches tall

The sizes were picked by measuring my adult furby(model) Buck so feel free to change it for different sized furbies

Put all there pieces on there fabric and cut you’ll need 2 cuts of pattern piece one from fabrics one, two and three, you’ll need one cut of pattern piece two from fabrics one and two, lastly you’ll need 2 cuts of pattern piece three from fabric 3 DON’T FORGET SEAM ALLOWANCE IT WILL FUCK YOU OVER (🫶🏾I did around 1 inch of seam allowance)

Layer fabric from pattern piece one in the order of one, two, three, just like the picture it’s important( also if it’s heard to tell fabrics one and two have their good sides facing each other)

Then sew all pieces like this