A Very Important Website

Etching was a huge pain in the ass! Worked out ok for both pedals but I couldn't get an etch as deep as I would have liked, ended up using a waterslide over top of the Life Pedal clone (right) as the black paint didn't go deep enough. Still nice effect and would probably try it again with a higher concentrate FeCl solution. The pedal on the left is a teensy 4 based midi controller with TRS IN/OUT/THRU, and midi out on the back.

Getting graphics ready to try my hand at acid etching some pedal enclosures.

Some panels getting layered up to move into kicad for gerberizing. Design for Omri Cohen.

Pulse Controller for a pulsar-23 and serge system

Finished a couple 208c cards from portabellaz. I added a triangle osc to the big one and a white/pink noise generator to the BOB

Various eurorack panels and modules I created in 2020/2021. Learned a lot during the pandemic. Hoping to release at least 3 4u pcb/panels in LW format in 2023.

Laying out a transistor matching tool called the YATMA2, liked the design but wanted a smaller board and usb-c for power.

low-gain matrix mixer build with banana jacks. there's a butchered endorphin.es 2hp power mounted inside with a power switch and barrel jack ported to the outside, all mounted in a fraptools 42hp case.

just realized how much darker they are than the real things

banana cables & nonsense <3

best frands

my first custom euro module, lost the kicad files

had one of these keyed mosstones for a minute, kinda wish i would have held on to it

a whole new world, my first banana gear

circuit bending my sk-1

teenage engineering sucks.

microphone amp i built for clippy em272 mics.. sounds great