#noisebox

1 2 3 4 5 6

Turn up the music

Matching voices

Always noisy

Hello, I'm [noisebox]

Cox - dox - fox - lost

Moving on before

I've found my place

7 8

It looks like it's about to rain

Nice to meet you

(I've seen her face)

What's your name

Pause the music

(what was her name)

9 10

Sorry, could you say that again?

How am I ? Awh,

(I'm good, I'm great)

I'm goo..reat

Grate - gate - inflate - freight

Fright - flight - fight - light

I heard thunder

(Lavender, that's a nice name

Though I can't breathe around it)

Forehead- drop of rain

howareyou?

How. Are. You?

<lightning cracks>

Sorry, I didn't get that

<pouring rain>

Alright, goodbye!

(it was nice to meet you)

Y-you too!

11 12 13 14 15

DIRTY DRONE SMASHISM is a small and raw drone synth with 2 synced SQUARE WAVE OSCILLATOR pairs, each with an OFF-SET dial for one of them. A 3 position toggle switch selects one of the pairs (½ with a lower  or 2/4 with a higher frequency range) or all 4 oscillators, when in the middle position (basically this is one half of the stereo DIRTY DRONE DEFROST). The complex waveform generated by the oscillators runs through a powerful resonant filter (based one the TOTAL CONTROL FILTER), which offers control over the LOW and the HIGH end with a dedicated pot, to attenuate the frequency or increase it towards slight distortion). additionally it has a RESONANCE control with an extra BOOST that can be engaged by a  toggle switch (left position). And of course a FILTER CUTOOF FREQUENCY pot for a wide sweep through the frequency spectrum. The output VOLUME can be set with a trimmer that is accessible on the side, next to the 3.5mm stereo mini jack output (output mono on both channels). An additional 3.5mm stereo mini jack input allows to insert a  external audio signal (mono) to the drones and let them run through the filter section as well (for some old school industrial vibes.) UV pover indicator LED. Face-plate made from a recycled brushed and embossed aluminum. Build in a ‘barebone’ style’ so on the bottom all solder points are accessible for circuit bending by body contact and some marked dedicated solder points for the output of the 4 individual oscillators, in case you feel like experimenting with that). Handmade by GRM for METSÄÄN. Always remember, kids: IF YOU CAN’T SMASH IT, SET IT ON FIRE.

Size: 100 X 63 X 30 mm

In/Out: 3.5mm mini jack (mono)

Power: 2.1mm socket,  9V DC (center positive) NOT INCLUDED!

SOLD.

The demo video below shows a build of a previous batch, it looks a bit different, but has the same functions.

The picture below shows an older build, but the functions are the same (it just misses the knobs and has another panel material)

here’s how the latest batch looks again. black knobs, brushed aluminum panel with hand embossed METSÄÄN lettering.