#im508

Customer Issue: When trying to purchase an upgrade on my IM508, I was prompted to upgrade the Personal Center first. However, the upgrade process failed and resulted in the following interface. How can I resolve this?

Solutions: Solution 1: 1. Long press the Hex Editor. 2. Click Hex Editor, Force stop, clear default, clear cache, clear data, and then act again.

Solution 2: 1. Long press the Hex Editor. Disable 2. Perform the function again 3. Setting>app>disable APK>enable the Hex Editor

We hope this is helpful. If you encounter any further issues or require additional assistance, please don't hesitate to reach out to our customer support team for further assistance.

Autel MaxiIM IM508S Key Programming Tool with XP200 Programmer All System Diagnostics https://www.obd2shop.co.uk/wholesale/autel-maxiim-im508s.html

In this article i will show you a BMW key programming case,how to use Autel IM508 to program a new smart remote key for BMW 320d 2008 E90 CAS3 by OBD.

BMW E90 CAS3 Smart Key Adding by IM508 Procedures:

Connect IM508 programmer to BMW E90 obd port

Select [IMMO]–>[BMW]–>[Smart Mode]

Then Autel IM508 will scan immobilizer system,engine system,transmission system.

When processing finish show you as below result,if you get fault code you need erase it before programming.

Press [OK] to continue

Select [Key learning]

After then,IM508 will show you the vehicle detail information as below,check and press [OK] to continue.

Note:

1.[Add key] and [All key lost] is available for current CAS

2.Key learning process requires networking to obtain data,please set up the network ensure that it is connected to WIFI and keep this state during the whole process.

Remove the key from the ignition switch.If it is a smart key,please take the key out of the car.

Please be sure to operate as required,otherwise this may make the vehicle abnormal!If the vehicle is abnormal after read out the key information,please try performing [Clear DTC] to make it back into normal status.

Read key information success!

Whether to do the backup of the original key data?

Press [Yes]

Autel IM508 Add New Smart Key for BMW E90 CAS32008 by OBD (7)

Input the file name and save it.

After file saved successfully,it show you the key information as below

Customer key is number 5,from 1-4 are all disabled,so can not program if not “Enable”

We back to Smart Mode menu,select [System Selection]–>[Immobilizer]–>[Cas3/Cas3+]

Select [Key Operation]–>[Enable/Disable Key]

Please insert a work key and switch ignition on first

Select [Key number 3],then press [Enable] button to activate it

Here i enable key 3,key4 and key7

Then back to menu to select [Key Learning]–>[Key learning by OBD]

Please switch ignition ON

Remove the key from the ignition switch.If it is a smart key,please take the key out of the car.

Key3,Key4 and Key7 are enable,here we select [Key3],the press [Programmer generation key]

Select [Semi-smart key]

Please connect the device to the programmer and put the new key into the programmer card slot.

Writing key,please wait

Generating dealer key success.Please insert the key into the ignition switch to start the car once.

If the Vehicle cannot be started,or the ELV is displayed on the instrument,please synchronize the ELV or DME according to the situation.