Officially ready to start painting with grout... before I keep picking at it anymore! š It's a few inches short of 3 feet tall at the tallest point. The tall spire is for appearance & climbing, and the round slate on the short section is both a cover for that hide & a basking spot - it sits right under the RHP, about a foot below. The base with 2 hides is all one piece, then each hide is a separate section, fitting together with wood dowels placed in the lower section so they'll sit flat if I set them down. Each hide has slightly different dimensions for some variety, but all come out to around the same volume inside.
I wish the front small spire was a little less puffy, but didn't want to lose the texture cutting it down. Other than that and a couple other minor quirks, I'm pretty happy with it so far! Hopefully the grout goes well.
