C10 Built Not Bought

Getting layout fiqured put; going to run dual nitrous bottles with single stage maybe... 8" downward firing sub and amp still have alot of wood work left then i will need to skeletonize it all to cut back weight but keep rigidity.

Another angle of mock up for spare. It sticks out a bit.

I think the spare is a bit wider than the original

Finally getting around to working on spare tire mount. Using new tire for mock up.

The beast photo shoot

The beast painted and being showed off. Getting ready to start interior work

Getting the nitrous situated need room behind it for center console but i think its going to be to far forward

Added some Merica to the truck just in case people didnt know!

Tailgate latches diy used stainless cable with stainless latches put some black braided wire around so it wouldn't be to flashy

Off with the old and on with my new Lokar shift linkage

Old shift linkage and new Lokar linkage

Bed step painted and installed. Now waiting on Summit Racing to deliver the drivers side and that part will be done. Just need to install new doors and reinstall front grill and exterior is done! Thanks for following and liking feel free to reblog

Bed step painted: underside black top side flat olive drab, wanted this theme to go throughout the truck.

Passenger side rear fender on now time to fit bed step

Front bumper painted to match the rear bumper. No more chrome since over budget couldnt to rechrome or buy new. Still looks good just need to wet sand and buff.

Bed cover on , new bumper and brackets done, and wired taillights

Driverside rear fender with spare tire dimple back on. Velcro on for the bed cover. The exterior is just about done for this project