#wire table

Bettie Page Standing #500

Ideas for a large, open-air, mid-century modern side yard water fountain deck remodel

http://www.viralleakszone.com/tutorial-for-creating-a-side-table-using-a-wire-basket/

Tutorial for Creating a Side Table Using a Wire Basket

diy, end table, occasional table, side table, wire table

Calling all repurpose-aholics: This side table project gave new life to not just one, but two household items that I was this close to putting into the donation pile — a wire laundry hamper and an old chopping board. And what a chic side table it turned out to be! Similar tables are sold by CB2, Ferm Living, West Elm, and Pottery Barn, but you can make your own using a wire basket, hamper, or waste bin (affordable ones are available online if you don’t have one), and an old round chopping board. Of course, you can also cut out your own wood circle using a jigsaw, buy a round wood panel, or use a large wood plaque. Let the repurposing begin!

Step 1: Remove Excess Hardware, If Any

If your wire basket/bin has handles, feet, or casters, remove them by using a pair of pliers (as shown below) and/or a hack saw if the parts are soldered or welded on. Usually, hampers are the only wire receptacles that come with these extra parts, but many wire storage and waste baskets don’t have them. The particular one I used here had handles that I removed with pliers as well as ball feet at the base which I, relatively easily, removed with a hacksaw (not shown in this tutorial).

Step 2: Sand

Sand your cutting board with a sanding block or electric sander to remove scratches and resurface the wood. Since I was going for that weathered industrial look, I wasn’t concerned with removing every single little scratch. If you’d like a more polished appearance, I recommend using an electric sander.

Once done, clean thoroughly to remove all dust.

Step 3: Finish

The cutting board that I used had a lovely end grain surface design which I wanted to preserve. So, to bring out the natural grain, I simply used a semi-gloss polyurethane spray as a finish. When using polyurethane, always work outdoors or in a well-ventilated area.

It took three light coats to achieve the look I was going for.

Step 4: Attach Tabletop to Base

With your tabletop upside-down on your work surface, place the basket on top and centered as shown.

Use the conduit straps, screws, and screwdriver to securely attach the wire basket to the tabletop.

As you can see here, it’s important to find conduit straps that fit snugly around the wire of your particular basket so that your tabletop won’t jiggle around on your base. The conduit straps shown here are for a 5mm diameter wire. I used six straps equally spaced around the circumference of the basket where it connected with the tabletop. Use more or less depending on the size and shape of your tabletop and base.