#thunder laser

So I tweaked a few settings and came out with this piece. This was done in LightBurn and lased on a stock Thunder Laser Nova 35-80. Tell me what ya think!

The post 3D Relief Engraving – Attempt 4 appeared first on LaserGods.com.

I was fairly certain this would not come out very well so I didn’t even document the process but it exceeded all of my expectations. I will do a follow up video soon and go through the entire workflow. Whatcha think? Stay tuned for more!

The post My 1st Attempt at 3D Engraving appeared first on LaserGods.com.

This is a quick demonstration on the Thunder Laser Nova 35 about one way the LightBurn camera functions can speed up your workflow.

The post First Test Run With LightBurn Camera Functions appeared first on LaserGods.com.

BE PREPARED TO ADJUST THE VOLUME . THE FANS ARE FAIRLY LOUD IN THE VIDEO.

Here is a test of Thunder Laser’s Air Assist Control using Lightburn. There are 2 modes for air assist. Cut and Engrave. The 2 air solenoids are controlled with the smart board. There are also 2 needle valves mounted on the front left panel so you can adjust the flow for each mode  as well as momentary push buttons to test the flow. When you press a button the corresponding stage activates for 10 seconds.

So now you can define high (Cut) or low (Engrave) air assist by toggling the air assist function in each layer. With air OFF you get the engrave mode automatically. So for engraving just toggle air assist off in the cut settings in lightburn. For cutting, toggle air assist ON and it will choose the cut air stage.

This also works in RDWorks and, depending on the version, it may offer ON and OFF in the drop down or CUT and ENGRAVE in the current version (this is specific to the Thunder Laser version of RDWorks). If you use a generic version of RDWorks it will function this way as well. All you need to remember when applying layer settings is that air assist OFF will activate the Engrave stage and air assist ON will activate the Cut stage. This means that one or the other air control stages will always be active so there will not be an instance where you get no air assist at all.

The post Thunder Laser Air Assist Control appeared first on LaserGods.com.

Today, I will show you how to make a Tractor. This will be your child’s best toy. The whole process is not too complicated, only cutting and assembling。 I think this is very interesting, please enjoy it! If you are interested in this project. Check this out!

  SEE THE FULL STEP BY STEP TUTORIAL AND FILES HERE

 The post How To Make A Tractor appeared first on LaserGods.com.