#papermakingmachine

Making pulp

1 Several processes are commonly used to convert logs to wood pulp. In the mechanical process, logs are first tumbled in drums to remove the bark. The logs are then sent to grinders, which break the wood down into pulp by pressing it between huge revolving slabs. The pulp is filtered to remove foreign objects. In the chemical process, wood chips from de-barked logs are cooked in a chemical solution. This is done in huge vats called digesters. The chips are fed into the digester, and then boiled at high pressure in a solution of  Paper sodium hydroxide and sodium sulfide. The chips dissolve into pulp in the solution. Next the pulp is sent through filters. Bleach may be added at this stage, or colorings. The pulp is sent to the paper plant.

Beating

2 The pulp is next put through a pounding and squeezing process called, appropriately enough, beating. Inside a large tub, the pulp is subjected to the effect of machine beaters. At this point, various filler materials can be added such as chalks, clays, or chemicals such as titanium oxide. These additives will influence the opacity and other qualities of the final product. Sizings are also added at this point. Sizing affects the way the paper will react with various inks. Without any sizing at all, a paper will be too absorbent for most uses except as a desk blotter. A sizing such as starch makes the paper resistant to water-based ink (inks actually sit on top of a sheet of paper, rather than sinking in). A variety of sizings, generally rosins and gums, is available depending on the eventual use of the paper. Paper that will receive a printed design, such as gift wrapping, requires a particular formula of sizing that will make the paper accept the printing properly.

Pulp to paper

3 In order to finally turn the pulp into paper, the pulp is fed or pumped into giant, automated machines. One common type is called the Fourdrinier machine, which was invented in England in 1807. Pulp is fed into the Fourdrinier machine on a moving belt of fine mesh screening. The pulp is squeezed through a series of rollers, while suction devices below the belt drain off water. If the paper is to receive a water-mark, a device called a dandy moves across the sheet of pulp and presses a design into it.

The paper then moves onto the press section of the machine, where it is pressed between rollers of wool felt. The paper then passes over a series of steam-heated cylinders to remove the remaining water. A large machine may have from 40 to 70 drying cylinders.

Finishing

4 Finally, the dried paper is wound onto large reels, where it will be further processed depending on its ultimate use. Paper is smoothed and compacted further by passing through metal rollers called calendars. A particular finish, whether soft and dull or hard and shiny, can be imparted by the calendars.

Paper is made from the cellulose fibres that are present in hardwood and softwood trees . Whether using wood or recovered paper, the first step is to dissolve the material into pulp, and this need pulper equipment. Regardless of the type of pulping process used, the wood or recovered paper is broken down into its component elements so that the fibres can be separated. The pulping results in a mass of individual fibres being produced. The fibres are then washed and screened to remove any remaining fibre bundles. The water is then pressed out and the residue is dried.