Designer of bicycles and special projects

New Prototype, this one, is the one.

x3 450ml water bottles in size M!

Finally I Made it!

With the last fail, we decided to make the tip of a flexible material (tpu), but not all the tip, only the top part. To print this two pieces together on the same print, we make like these tubes that pass into the pla piece to stick together.

The rocket didn't survived so much time.

Unfortunately the parachute didn't open on the 2 test...

New rocket... The Stardust. This rocket is designed by me and one friend, and we pick the parachute mechanism of Air Command Rockets.

System:

The rocket works with pressured water and air.

The Parachute mechanism is based on Air commend rockets system, and we put an altimeter that measures the altitude, and wen the rockets fals this altimeter send a signal to the servo motor.

Materials:

All the pieces except the fins are 3d printed (pla), and the fins are a laser-cut wood of 2.6mm.

Electronics:

x1 Arduino Nano

x1 Servo motor

x1 Bmp280 (altimeter)

x1 9v rechargable battery

Midplane photo.