Untitled

This is my pattern for the wings. It is based on Tinkerbells wings.

With my pattern I shaped my wings with 2mm thick aluminum wire. It was easy to bend. When your wings are taller I would recommend to choose thicker wire. 

First I placed the first wing part on organza fabric and cut a right sized piece from the fabric. Then I took the wings and put glue on that side of the wire that should be the beautiful side of the wings. Next I layed the wing part onto the fabric, then I turned the wings around so the fabric is on top of the wings (because the glue leaked through the fabric and got stuck to the table) and let it dry. Next turn the wings around again and place glue to the upper side of the wire and wrap the fabric around the wire. Let it dry again. At last cut away the excess fabric and do it all again with the other wing parts.

For the lines I used liquid glitter glue. I placed my wing onto the pattern and drwan the lines. But again be careful. The glue leaked through the fabric and got stuck to paper.

Here you can see one of the finished wing parts.

I wanted my wings to glow under UV light. For that I used green glitter glue. But as it was dry it didn’t glowed anymore as you can see in the picture :(

So I put on all lines glow in the dark Nailpolish. 

WELCOME TO OUR CLUB! WELCOME TO OUR CLUB!