suprfury./com

SSH to your NAS. Use ipkg to install transmission. Do an ipkg update first.

ipkg install transmission

sleep 5

Create necessary file for transmission. replace /mnt/disk1/tmp to whatever working folder that you are using in your NAS.

/opt/bin/transmission-daemon -g /mnt/disk1/tmp/torrents/.config/transmission-daemon killall transmission-daemon sleep 2

I use nano to edit the config file. Install nano via 'ipkg install nano'. Edit the config file.

nano /mnt/disk1/tmp/.config/transmission-daemon/settings.json

Take note on the importants. refer to the complete list at https://trac.transmissionbt.com/wiki/EditConfigFiles

blocklist-url: String (default =  http://www.example.com/blocklist)

blocklist-enabled: Boolean (default = false)

download-dir: String (default = default locations)

rpc-whitelist: String (Comma-delimited list of IP addresses. Wildcards allowed using '*'. Example: "127.0.0.*,192.168.*.*", Default: "127.0.0.1" )

rpc-whitelist-enabled: Boolean (default = true)

rpc-port: Number (default = 9091)

To run transmission

/opt/bin/transmission-daemon -g /mnt/disk1/tmp/.config/transmission-daemon

Launch your browser and point to your NAS_IP:9091. Done.

From the webgui, click System > Software. Update the lists.

Find 'dns'. Install 'luci-app-ddns'. Once finish, click Services > Dynamic DNS.

This will change your OpenWRT IP address, and update the DHCP scope accordingly.

Assuming you have a working OpenWRT box. Objective is to 1) configure VLAN 500 (data) and 600 (IPTV) in Port 1 (WAN). 2) configure WAN to use PPPoE and 'dial' UNIFI and 3) configure port 5 as IPTV.

Login to OpenWRT then tab Network > Switch. Refer below:

Save & apply. Then tab Network > Interface. At WAN, click Edit. Change Protocol to PPPoE and confirm protocol change. Click Save & apply.

Key in UNIFI username and password and leave the rest as default. Click Physical settings and choose VLAN interface eth0.500.

Save & apply.

Plug in the connection from BTU to WAN port. Go back to interface and click Connect. You should achieve objective 1 and 2.

Now go back to Interface and click Add new interface at the bottom of the page.

Download latest OpenWRT build for 1043ND (Backfire). 1043ND is using Atheros 71xx chip.

http://downloads.openwrt.org/ > backfire/10.03.1/ar71xx/ find 1043nd. The current build as when this guide was written as below:

http://downloads.openwrt.org/backfire/10.03.1/ar71xx/openwrt-ar71xx-tl-wr1043nd-v1-squashfs-factory.bin

Unplug WAN port and use port 2 or 3.

Login to 1043ND webgui and upgrade the firmware using above file (*.bin). Wait until reboot.

Default subnet for OpenWRT is 192.168.1.0/24. Keep ping-ing to 192.168.1.1 to check when it is up. Point your browser to 192.168.1.1.

Default username is root, without password.