Chamak Nikar Garage 🇧🇪

Front and back center seam are now ready, not working on the side.

Use textile glue are the edge of the back panel and let is dry.

Prepare a bias band in thin nylon fabric.

Iron the bias band when the glue is still soft but dry. Use a single straight stich to secure the bias band.

Now working on the front panels.

Make a seam on the front of the fabric with the tape

Set a second tape to hold the striped band, just near the seam.

Sew the striped band on to the seam using 2 colors thread.

I use double sided water solutiable tape. Set it 2 mm from the edge from top to crotch on the right side.

Set the second part as close to the edge. Then immediately set the first straight stitch at 8mm.

The tape is 6mm and de 2 mm gap makes sure the stich is just at the edge of the tape

Now cut the 2 mm to make sure both sides are exactly the same.

Set the machine to zigzag to secure the edges.

Set the fabric so the needle is just over the edge of the fabric.

Set a second straight stitch as close to the previous straight stitch.