drone journal

An alternative way to mout is by cutting the canopy using penknife. Use hot glue to keep it in place. But i still prefer to mount directly on the board using some double sided tapes

Eachine e010 with all stock parts and tx01. It flies great with the 150mah lipo bought from banggood, giving about 2min 30sec of flight time(conservative timming)

To flash the board with betaflight 1. Download the latest betaflight hex file. 2. Connect the bootloader pins together and plug it into the computer. This is to set it to bootloader mode. 3. Select ‘no reboot’, ‘manual buad rate’ and ‘full chip erase’. 4. Load the hex file from local 5. Before clicking flash firmware, make sure bootloader pin is connected. 6. Cleanflight/betaflight configuration will show the necessary