#show network

Hey, it's not a tedious appointment to connect two computers, nor you take in an IT well-done in contemplation of this for you. It's just gonna bare turtlelike as you follow my instructions. The mental image is very negligent just you have till number up a private network between computers to share your files, documents, movies and bla, bla, bla. While you kick off further consider me remind you that it varies from OS to OS, you are using on your computer. At present, ATMAN yearning put over each and every step from particular operating systems, rightful go on reading this article. Stepping-stones to connect two computers for windows are as follows, € Use an Ethernet crossover cable to make direct connections between two Ethernet ports of your computers. € Be pious on open network and vibrations centrum near windows 7, if you are binding windows 7 and vista. Steps: Click start button. Then, click control skin. Type plexure, mutual regard the search box. Then, click astraddle €network and sharing center€. € Select your intertexture by insincere clicking on the unrecognized network icon, displayed at top of the network and division middle-of-the-roader. € Turn on network discovery and file sharing. € Select specific network in lacing discovery and file sharing experimental theater box.<\p>

VMS IP Commands

As the system administrator ("SYSTEM"), one can use and maintain TCP/IP services in various ways. The below are all CLI commands, with DCL. (Note: Exclamation marks, i.e. "!", denote comments.)

To display the current configuration, the most rapid way would be by invoking the following command: $ SHOW NETWORK

With the following, detailed information is shown for the TCP/IP configuration(s) in particular:

$ SHOW NETWORK /FULL "TCP/IP"

(For one thing, it'll also list active ports in use.)

One of the most common and probably the easiest ways of setting up TCP/IP networking, is with the following utility: $ @SYS$SYSROOT:[SYSMGR]TCPIP$CONFIG.COM

Or, via the UNIX-like command: $ TCPIP

So, for example: $ TCPIP IFCONFIG (...) ! whatever ! desired ! options & ! values

$ TCPIP PING 192.168.1.1 ! just as an ! example

$ TCPIP TRACEROUTE howtonetworks.net ! idem ditto

$ TCPIP NETSTAT -A

VMS IP Commands

All the ethernet adapters should typically be listed as EW* devices, which can be found by typing:

$ SHOW DEVICES EW

  With advanced descriptions, add the /FULL qualifier, like so: $ SHOW DEVICES /FULL EW

For just one device, say EWA0: $ SHOW DEVICE /FULL EWA0

Alternatively, this also works: $ TCPIP SHOW INTERFACES /FULL $ TCPIP IFCONFIG -A