This'll work! Maybe? So, for those of you that invested in the Moai SLA Printer, may have experienced an issue with the SDCard reader. The reader goes out more often than I would like it to, and one possible reason is that when you install it, the screw mounts are too shallow making it stress the PCB. That's my solution! A spare piece of styrene 0.08 inches thick. I scored it and put it into place after drilling out the screw holes. I can't go any thicker because the included screws are too short. Peopoly was nice enough to include extra screws but I have them packed away so I don't know if there are others that would work. I am still able to remove the SD Card without any difficulty, outside of what there was initially with my big fingers. I hope this helps you too! #moai3dprinter #moaiprinter #3dprinting #modifying #sdcardreader #cardreaderissue #peopoly #matterhackers #slaprinter #sla3dprinter #3dprinter https://www.instagram.com/p/BxV7uOXDlYn/?utm_source=ig_tumblr_share&igshid=1omv7v5ithru5
