#ledlightdiy

Register as a member of the website and get a share link. Link sharing gets a 10% commission on the order.

1,Anti-static: Because LED is an electrostatic sensitive component, if you do not take anti-static measures when repairing the LED strip, it will burn out the LED and cause waste.

2,Continuous high temperature: The two important components of LED strips, LED and FPC, are products that cannot continue to withstand high temperatures. If the FPC continues to high temperature or exceeds its withstand temperature, it will cause the FPC cover film to bubble and directly cause the LED strip to be scrapped. At the same time, LEDs cannot withstand high temperatures continuously, and their chips will be burned out at high temperatures for a long time. Therefore, the soldering iron used when repairing the LED light belt must be a temperature-controlled soldering iron, and the temperature is limited to a range, and it is forbidden to change and set at will. In addition, even so, it is necessary to pay attention to the soldering iron not to stay on the LED pin for more than 10 seconds, if it exceeds this time, it is likely to burn the LED chip.

The light strip refers to the LED light is welded on a copper wire or a strip-shaped flexible circuit board with a special processing technology, and then connected to a power source to emit light; it is named because it is shaped like a light strip when it emits light.

The earliest process is to weld the LED on the copper wire, then put on the PVC tube or use the equipment to directly form it. There are two types of round and flat. The title is distinguished by the number of copper wires and the shape of the light strip; two wires It is called the second line, the circle is added with a circle in front, that is, the circle is two lines; the flat shape is added with the word flat in front, that is, the flat two lines.

Later, it developed into the use of flexible circuit boards or FPC as the carrier. Because of its simpler processing technology, easier quality control, longer life, higher color and brightness, it gradually replaced the earlier processing technology, and it has gradually become a trend.

Conventional round two lines, round three lines, flat three lines, flat four lines, etc.;

The colors are red, green, blue, yellow, white, colorful and so on.

Diameter: 10mm~16mm. It is widely used in building outlines, bridges, guardrails, hotels, forest gardens, dance halls, advertising decoration places, etc.

How to make SKY BLUE on LED Light Strips!

Custom DIY Light Strip Colors #1

How to make NEON GREEN on LED Light Strips!