#hate wraith

I have one finished Hate Wraith mask in the shop right now! http://missmonster.myshopify.com/

I have two Hate Wraith masks in the shop! Ready to ship. http://missmonster.myshopify.com/ Ready to wear, finished and painted mask. Each mask is painted with layers of gold and reds. The cracks of the mask are fluorescent orange and glow in the dark resin drips off the sides and top. Charge it in sunlight or blacklight and the drips will glow orange and teal.The black eyes can be seen through.

You can also replace the black screens with reflective plastic visor material:

Icon Props at etsy

These masks are lined with foam and have elastic straps attached. You may need to add or subtract the foam to get it to fit you just right. You can also widen the mask with heat if it is too small: If the mask does not fit use a heat gun on the inside or heat in the oven at around 175 degrees for a few minutes. Set the shape you want by leaving on an upturned bowl or object to hold the shape while it cools. 

- This is not a piece of safety equipment, this is a wearable prop. Please use common sense.

-Please treat this piece of artwork carefully.

-This mask fits most faces but a perfect fit is not guaranteed.

- Do not use this as safety equipment or a welding mask or anything else but costuming. Please don't make dumb choices with this. I am not responsible for injuries sustained through improper use of this mask.

Two rust effect Hate Wraith masks are in the shop! http://missmonster.myshopify.com/

Ready to wear, finished and painted mask. Both of these have been hand painted to resemble rusted metal. The black eyes can be seen through. You can also replace the black screens with reflective plastic visor material: Icon Props at etsy: https://www.etsy.com/shop/IconProps

These masks are lined with foam and have elastic straps attached. You may need to add or subtract the foam to get it to fit you just right. You can also widen the mask with heat if it is too small: If the mask does not fit use a heat gun on the inside or heat in the oven at around 175 degrees for a few minutes. Set the shape you want by leaving on an upturned bowl or object to hold the shape while it cools.

- This is not a piece of safety equipment, this is a wearable prop. Please use common sense.

-Please treat this piece of artwork carefully. -This mask fits most faces but a perfect fit is not guaranteed.

- Do not use this as safety equipment or a welding mask or anything else but costuming.