#eclipse 2g

Pistons and Connecting Rods Assemble

Assembled my connecting rods into the JE Pistons. I think the hardest part was assembling the circlips.

Add a lot of assembly lube to be sure that it will be lubed when your car first start.

https://amzn.to/2RjhgCX – Assembly Lube https://amzn.to/2CBOLbv – Manley Connecting Rods (MAN-14004-4) https://amzn.to/2SqO5vk– JE…

Polishing Engine Head Ports

After getting my aluminum engine head back from Gibson Performance the show where I asked them to clean and blast I got left with a few tasks: 1st I needed to lap the valves 2nd Polish the ports so the air would flow faster specially out of the engine without restriction(small porous)

I have been reading a lot about ported…

Engine Block and Head Washed

Took the block to the shop so it could get washed since I found a particle between the bearing and crankshaft.

The shop I took was Gibson performance http://www.gibsonperformanceengines.com

They did such a good job that I decided to take the engine head and some other parts also.

Engine head got also Blasted. Now I…

Universal Piston Ring Filer from Summit Racing

Got this filer at Summit Racing online. It was delivered quickly and it looks pretty good.

Don’t take this as a tedious job. It is probably one of the most important jobs of building an engine.

If the gaps are too tight then you might be in big trouble when it hits up. Too much of a gap then you get Blow by. You will…

How to Clean Carbon Deposit from Valves

I needed to clean my valves since it was terrible. There was so much carbon deposit that I doubt that it was sealing properly. Using Scott Bright sponge I was able to clean the carbon deposit.

I needed to clean my valves since it was terrible. There was so much carbon deposit that I doubt that it was sealing properly. Using…