#eastern model

the light gray parts on the thighs and biceps are 3d printed.

https://www.tagimi.net/?pid=165425415

With everything going on, I finally had a moment to open Ultraman version 7.3 by Dimension Studio X Eastern Model (and this free sample from YOLOPARK). There are a lot of unboxing out on the internet so I’m going to skipped this process. I’ve attached some sample images before I start building this kit. There are two version of this kit I believe. I think there is a chrome plated version (pictured in the instruction) and the sample I received was the standard version. The kit comes with electronics, clear parts, polycap for the joints, water slide decals, and so forth. The details are there but a bit thick and not as crisp as what you would find with Gundam kits produced by Bandai or Macross kits from Hasegawa. I did noticed the parts connected to the runners uses an under-gate process so if the kit was platted, there would have be minimal clean up. For builders who paints their parts on the runners, this is a great feature so a builder can paint the parts on the runner first and then snip them off to assemble.

https://www.tagimi.net/?pid=154866821

https://www.tagimi.net/?pid=155260817

https://www.tagimi.net/?pid=162418192

https://www.tagimi.net/?pid=163865529