Materials are mostly self explanatory, but the chalk is for drawing the pattern on the felt, the glue gun is for attatching the mouth, eyes, and security badge to the plush, and the wire is to go through the body/neck/head so his head isn’t floppy. ALSO you’ll need scissors to cut the felt out (forgot to draw that lmao)

This is the pattern to draw out on our lighter felt for the head and body! This is specifically for Dave, but if you’re making Jack you can adjust the proportions on the body to be a bit shorter and wider. These are in centimeters because I am not American.

Cut along these lines, you can cut out each panel but I’m lazy so this works just fine.

You’re kinda turning these into cubes, think of it like one of those paper maps you probably made in elementary math class. Fold along the lines and use a whip stitch to attatch the pieces together AS WELL as stitch along the chalk lines-- that will make it look like you actually cut all the panels out and define the different sides. 

should start to look like this! Make sure to leave one side open so you can flip it inside out!

Once it’s inside out, you can stuff it and use a ladder stitch to close the last side. I reccommend leaving a shorter side open so the ugly stitch is less noticable. 

Once you’ve cut out the mouth, eye, and badge shapes you can glue them on!

Here’s where it gets. a little jank so buckle up!

This is the general pattern for the arms, legs, and neck. You’ll have to futz and adjust it... a bit because I am not stellar at making patterns, but this is good to get ya going!

This time cut out each panel

Also to note- If you’re making Jack you do not nead that much neck lmao

OKAY sO for stitching, this time it’s less straightforward. For the legs I folded each rectangle in half (Ugly side out!) and just stitched along the edge to make a tube

Kinda like this

Then flip it inside out, stuff, and fold and crease it to look like a foot using a whip stitch. To extra secure it I did a ladder stitch along the top to keep the foot upright

Then just pull the thread tight and boom you got a leg. Repeat that on the other leg and now he can walk.

Attatch it to the ass with a ladder stitch (and also secure it along the top with another ladder stitch to keep him in a sitting position if you want)

Now for the arms

So this is probably the most jank part of the tutorial. For the arms I ended up adjusting the pattern I had cut out to look more like this.

Then you just kinda

fold and pin it to get a boot-like shape. Use the extra fabric you cut off the bottom of the arm to make a little oval for the palm and then stitch it all together (leaving the top open). Then flip, stuff, and attatch with a ladder stitch!

mans kinda built like an Ugg boot. 

Lastly the neck is literally just a tube. If it’s Dave make it long. Just stitch along one side and leave the two ends open so you can put the stuffing and wire inside. Now for the Wire! To make sure it can’t puncture through the felt, bend the ends to look like this

Now to run it through him just take some scissors and snip two lil holes, one at the bottom of his head and one in the middle of the top panel of his body and have the wire go through his body, neck, and into his head. that’ll make his neck bendable. Then just attatch the neck with a ladder stitch and you have your man! For Dave just bend the neck into the desired potition aaand you’re done!