Aug 12, 2019
So, instead of removing the blades from the Delta 654 jointer I did a little tune-up on them in place. They weren't chipped or dulled enough to warrant regrinding them. So I pulled out a small piece of oil-stone and went to work on them. After honing them back to a sharp edge I did a few test cuts. The results were quite impressive! Even with the squirrelly grain at its end this piece came out glass smooth! It's hard to beat good quality steel! #deltamilwaukee #delta37-595 #delta654jointer #vintagemachinery #vintagewoodworkingtools #oldschoolpowertools #deltacombomachine #woodworking #woodworker #sharpening #oilstone #jointerknives #razorsharp (at Screven, Georgia) https://www.instagram.com/p/B1Cyw5YF993/?igshid=k5vi9tzctw7i
