#aluminiumcoating

RWIP120 Two-Pack Epoxy Primer Finish This high-performance coating for the rail industry is an epoxy air-drying solvent-based coating, with low VOC content, specially developed as a single coat application, or multi coat system for application to a wide range of substrates. RWIP120 is part of a family of coatings manufactured from a high grade two-part epoxy system initially procured for use in aerospace applications and developed for use within the rail industry on underframe components, including wheelsets, bogies, air reservoirs and motors (new and refurbished) and heavy engineering. RWIP120‘s performance covers a long list of rail industry challenges. Including impact, chip and scratch resistance and the ability to withstand high humidity. Alongside resistance to abrasion, salt spray and wash plant operations. The cured coating provides excellent corrosion protection on steel, aluminium and galvanized substrates, as well as in immersed conditions. It is a tough, chemically resilient finish that has been tested against a variety of corporate and national standards. The coating performs in temperatures ranging from +200 ºC. down to -50 ºC and can also be applied directly to GRP and composite substrates. Applied as a single or two coat application, by airless spray, conventional spray, or brush / roller, and can be overcoated with itself or other Indestructible Paint finishes, epoxy’s and polyurethanes. Read the full article

Sacrificial Aluminium Basecoats and Sealcoats Ipcote IP9183-R1 Basecoat and Ipseal IP9184 Sealcoats IP9183-R1 Ipcote Sacrificial Aluminium Basecoat is part of a range of corrosion resistant coatings designed for use in challenging environments such as aero engines and components, power generation turbines and marine engines. Ipcote is applied by conventional spray for use on compressor blades, rotors, shafts and landing gear to provide protection from salt laden atmospheres, high temperature oxidation, chemicals and abrasives. The coating provides corrosion and oxidation protection to iron, steel, heat treated stainless steel alloys, titanium and other metallic substrates at temperature of up to 700°C. Ipcote can also be super or vibro polished to enhance flow of air in aircraft engines where smooth surfaces are essential to enhance energy efficiency: when vibro polished a Ra surface finish of ≤ 12 micro inches is readily achieved. Protective Sacrificial Sealcoats for Aero Engines that Improve Engine Efficiency Ipseal IP9184 is an inorganic protective coating used as a barrier on Ipcote. Available in green, khaki and blue to meet specific client requirements. Ipcote coatings are conductive, sacrificial coatings but are inherently porous. Ipseal seals this porosity without detracting from their sacrificial properties. It also creates an electrically non-conductive barrier coat. Read the full article