So I’ve got my hands on some clear resin and I’ve been working on making some fishy habitats. I opened up the resin packaging and read all the instructions carefully, and it said the unset resin will wash off with soap and water. So I got to mixing and making little piping bags to get the sand-resin mixture to the bottom of the little jars, getting sandy resin all over my hands because I hate gloves and they give me blisters, and by the end I’ve got a few good starts and resin-sand mixture all over my hands. So I go to wash it off and guess what? It does not wash off with soap and water. Not even a little. Okay, this happens, so I get out the methylated spirits and no. That doesn’t work either. Whatever is in this clear resin is immune to both polar and non-polar solvents, and may be unknown to the world of science. I had to wait 6 hours for the damn stuff to set before I could touch anything, sitting in my blanket nest tapping the kobo with my toes to change the page. Moral of the story: always wear gloves when dealing with two-part setting solutions.














