Match Grade Creations

Next I'll make the sight rail, It will contain the hammer the swings downwards yeah kinda bassacwards I know, but all this stuff gotta fit really low in the web of your hand.

Nose cap installed , there's a flange on the barrel that fits into a recess in the frame, This barrel cap fits over the flange sandwiching it in place.

Tapping threads for the nose cap

Drilling holes for the recoil springs

After some time away I'm back working on this pistol, Got the 5 round mag done and got it hand cycling thru the pistol next I'll build the barrel end cap a sort out the recoil spring.

Mag catch fitted.

1 tube mag almost done, gotta make a plunger and end plug to go on ether side of the spring.

Milling a slot for mag catch & lower trigger guard

There's a slot cut in this that will hold a spring loaded catch, As the carrier comes down it will push down on the catch releasing the round, I'll work on it next, ran out if time for now.

Finely got to work on this more today, building the tube Mag.

The 2 dent balls and the spring fit in to the hole in front of the carrier and holds some tension on the Carrier in up and down position, The ejector has a spring that holds it in the upper position while the carrier is in the down position and is compressed slightly when the carrier is in the upper position.