MUTANT

This is to show how the pattern was made in Lectra for the life vest.

I started off with a basic block for front and back; making the head and arm holes slightly bigger,

I then draw out the shapes of the tubes. I measured the length of the tube the red line represents the length of the tube. 

I then aded 50mm on either side of the red line to create the green shape. these shapes represent the lining of where the tube will be.

This shape I then used move and marry to extract it from the block and enlarge.

The tube needed to be 100mm wide to be wide enough to go over the tube and allow it to budge out the front and not stick out the back. So to do this I split the  piece length ways in half and added this in the middle.

I then extracted the new shape from this.

TECH_PACK

I decide to make my tech_pack as an animation as its meant to show you how you could replicate the tent jacket with you own tents. I have also included a section at the end where it shows how to put up the tent as I doubt that many people would know how to and I think this would come in very handy.

Updated colour palette