#x431 key programmer

The Launch X431 IMMO Elite key programmer now supports ID48 (96-bit) online calculation for VW vehicles. To perform this function, you will need to use the X431 Key Programmer. Follow the step-by-step guide below to easily complete the process.

Operation Guide:

1. Insert the original key into the Launch X431 Key Programmer to read the key information.

2. Select "ID48 (96-bit) Online Calculation" to clone the chip data.

3. Follow the on-screen instructions and click “Start Clone.”

Insert the original key into the LAUNCH device to recognize the key.

Place the LAUNCH antenna close to the car’s ignition switch (detection coil) to collect data. For a normal remote key: Insert the original car key, turn the ignition on, then turn it off, and remove the key. Repeat this process until data collection is complete. For a smart key: Remove the key’s battery, place the smart key near the detection area, and turn on the instrument cluster. Turn off the ignition and remove the key. Repeat this process until data collection is complete. For Volvo models: Collect one set of data at a time by disconnecting the power before collecting the next set.

5 Steps to Calculate ID48 (96-bit) Online:

Identification

Sniffer Data

Upload

Calculation

Query

After successfully cloning the chip using the X431 IMMO Elite and Key Programmer, insert the cloned chip into the key to start the vehicle. The vehicle can now be controlled separately.

Launch X431 IMMO Plus/IMMO Elite with X431 Key Programmer can generate remote and program smart key to 2023 KIA K5 (DL3) perfectly.

1.Read transponder: Confirmed

2.Detect frequency: Confirmed

3.Generate remote: Confirmed

4.Read data stream: Confirmed

5.Add smart key: Confirmed

Tips & Guide:

To perform the supported function, need to connect X431 IMMO Plus/Elite to the network, and update key programmer software to the latest version.

Connect X431 tablet, X431 Remote Maker, and vehicle correctly

Select [Update] to check if the software is in the latest version. If No, update it first. If Yes, go to next step.

1.Read transponder

Put the original car key into the coil of Launch Key Programmer to identify the chip info.

Remember the car key chip model after reading (It’s transponder 47)

2.Detect frequency

Select [Frequency detection], still put the original key into the key programmer coil, and press the key remote control button to identify the key frequency

3.Generate remote

Select Vehicle Remote>> KIA>> All remotes>> Optima (2015-2019) KeylessGo ID47>> Generate

Burn successfully

4.Read data stream

Select Kia immobilizer diagnostic software>> Immobilizer Key Matching

Detect VIN code successfully

Select General Area>> K5 (DL3) >> 2023>> IBU (Integrated Body Control Unit)-SMK>> Read Data Stream

Click on “Select All” to read data stream fast

5.Add smart key

Back to the last page, and select Special Function>> Smart Key Code Saving

Turn ignition off and prepare an FOB key to teach

Input 6 PIN code

Note: this function may be limited if the PIN code is entered incorrectly three times.

1st key teaching…press SSB (Start Stop Button) using 1st FOB within 5 seconds

Do not use your figner to press SSB, just use FOB itself

1st key teaching is completed, use the same method to teach the second FOB key

2nd key teaching is also completed.

Finally, test the remote function of two keys and check if the keys can start the car.

Done!

How to Upgrade and Setup Launch Tool to Work with X431 Key Programmer Remote Maker?