Hi, I'm wondering how to style a synthetic wig without any heat as I don't think it's even a little bit heat resistant. I basically need to make it flick out at the ends, also how to detangle a curly synthetic wig? Basically, I fail at wig care
wigs that aren’t heat resistant are usually styled with the “Hot Water Method” where hot water is used as a heat source to set a style into a wig. The hot water used in this method is often from the tap, as boiling water can be too hot. I suggest using a small amount of hair from the underside of the wig as a test piece to see how much heat your wig can take. Then adjust your water temperatures accordingly. For a flip, you can curl the ends with rollers and pour the water over top.Another option is to not set the style into the wig and use hairspray to hold the curl in place. I do this by spraying a strand with a bit of hairspray and wrapping it around a hair roller. Then I spray the outside with some hairspray and let it fully dry. Then I remove the roller. Sometimes I will use a bit of white glue to hold the tip of the curl together. For Detangling:
Start on one side of the wig. Grab a small amount of hair and section off the rest of the hair using hair clips.
Starting from the bottom of the strand, work out the tangles using a wide toothed comb. Then move up an inch, and work out the tangles. Repeating until you reach the top of that strand and it is tangle-free
Then move onto the next strand and repeat until the entire wig is detangled.
Tips:
Wig detangling spray, skin-safe silicone lubricant or fabric softener and water can be used to help work out stubborn knots.
Yes hair will be pulled out, it’s going to happen and it’s best not to stress about it
Sometimes a tangle might be too crazy to work out, in which case you can cut it out. This may mess up how your wig is styled.
You may need to re-curl the wig after detangling, since the stress may loosen the set-in curls.
Hope this helps!
