#thingomatic

More #Makerbot #3Dprinter action. #3dprinting #ThingoMatic #arduino

#MakerBot back in action! Essentially, the #obsolete, dialup-modem-equivelant of #3Dprinting now days 😒 but hey, she still works like a champ! #thingomatic

Honored to have Proto-pasta materials be part of this design evolution! #repost @g30ff4y - #3dprinted #speaker enclosures Front: tiny proof of concepts (2014, @makerbot #thingomatic #3dprinter in #abs) Middle left: MTM prototypes (2015, #mendelmax2 in #proto_pasta #carbonfiber PLA) Middle right: 7+1 TM (2016 #mendelmax3 #protopasta #carbonfibre & #steel PLA) Back: MFA Line Array (2015-16, #mendelmax3 Proto-pasta #carbon #fiber & @colorfabb_official #bronze #metal Latest design (not shown here) with help from @gcreate3d & @hatchbox3d @parts_express components #3dprinting #3dprinted #3dprint #community #education

#designevolution #3dprinted #speakers Front: tiny proof of concepts (2014, #thingomatic #abs) Middle left: MTM prototypes (2015, #mendelmax2 @proto_pasta #cfpla) Middle right: 7+1 TM (2016 #mendelmax3 #protopasta #cfpla #sspla) Back: MFA Line Array (2015-16 #mendelmax3 #cfpla and @colorfabb_official #bronzefill) these will be receiving a big update being revealed tomorrow with some additional prints by the folks @gcreate3d #daytonaudio and #hivi drivers from @parts_express (at University of Montana)

Left: Current model revision printing today. Right: Failure comparison. After further analysis last night and this morning I was able to take a better look at the model as opposed to the printer. While making modifications to stainless steel drive gears from the #thingomatic there were still issues when printing in the same spot, same layer. Two major changes with the model: 1. Added additional internal chamfers both above and below the middle concave section of the model. This only roughly adds an estimated <10cm^3 volume to the model, but cuts down print time by nearly an hour by #kisslicer estimates. 2. Flipped orientation of the model 180 degrees on the build plate. Still had some hiccups with some shredded filament at the drive gear, but was able to catch it right as it happened. Still on track #mfa (at University of Montana)

My first PLA print. #CalibrationCube #3dprinter #3dprinting #3dprint #3dprinted #3dprints #makerbot #thingomatic #thingiverse #impresora3d #3dmodel #3d #3дпринтер #3дпечать #flashforge