I edited together all of Batty's parts from the first movie. Here's a very compressed gif too
seen from China
seen from Poland
seen from South Korea
seen from Belgium

seen from United States

seen from Netherlands
seen from Germany

seen from Sweden
seen from China
seen from China
seen from China
seen from United States

seen from United States

seen from China

seen from United States
seen from Japan
seen from United States
seen from Dominican Republic
seen from United States
seen from United Kingdom
I edited together all of Batty's parts from the first movie. Here's a very compressed gif too

Anya is live and ready to show you everything. Watch her strip, dance, and perform exclusive shows just for you. Interact in real-time and make your fantasies come true.
Free to watch β’ No registration required β’ HD streaming
Internals of a Flip Video Ultra F260 camcorder from 2006
second attempt at PCB etching (first with toner transfer). it shinyy.
originally tried photoresist process, but my laser printer couldn't produce opaque enough black so it kept getting exposed where it shouldn't. also i think leaving your photoresist in a hot shed for years before using it isn't good.
this one was toner transfer from the same overhead projector sheets at 130C on a hot plate with a rolling pin, i think it could stand to be a few degrees hotter. had to touch it up with marker. etched with ferric chloride solution, which took a long time cause i didn't warm up the solution effectively.
a few traces missing around the edges, and plenty with small breaks in them, but no short circuits at least (although theres a few close ones). good enough to test the part of the board i want to test. i'll do another try later.
definitely learning a lot about the design and routing process too.
the griffin from quest for camelot
preciiisely~