This is a cosplay of Kululu/Kururu isguised as a Pekoponian I made for OMGCon 2017. The mask is made of a glue and water based paper mache. I'll list the materials used for the mask and remote below.
Photo is taken by Pense Productions
For the mask:
Punching balloon
Water/Glue mixture
Newspaper cut into strips
Yellow spray paint
White acrylic paint
Black acrylic paint
Clear coat
Orange fleece for the hat
Foam ball cut in half
Pewter gray acrylic paint (use on foam ball)
Black felt
Yellow felt
White tulle (use enough where you can't be seen in the mask; roughly 4 layers)
Black sharpie
You will need scissors, paint brushes, a knife, and a hot glue gun for the mask. You will also need a sewing needle and white thread to sew the tulle together. I also recommend using an x-acto knife to cut out the eye holes. The wheel from the white tulle helps with keeping a consistent size for the eye holes. Use the eye holes as a guide for cutting the pieces of tulle so they're large enough to be glued inside. I dont remember the exact amount of tulle layers used, but i believe it was 4-5. After wearing the mask, I'd just recomment using just enough where you cant be seen inside but also where you can see well enough. I also recommend using 3-4 layers of paper mache to keep the mask sturdy though it will be more difficult to cut the holes for the eyes and your head this way. I used 2 layers of paper mache if you want to use the exact amount.
It will get hot in the mask and you won't be able to use your peripheral vision while wearing it so be careful.
For the remote:
Plastic VHS case
Radio antenna
Silver duct tape
Red acrylic paint
Round makeup sponge
You will need a hot glue gun, a paint brush, and a power drill with an auger attachment. The auger attachment is used to drill a hole in the case to slip the antenna through it. Glue the sponge onto the base of the remote after it dries and you've coated the VHS case in duct tape.
