seen from Singapore
seen from Malaysia
seen from Singapore
seen from Germany
seen from Malaysia
seen from United States
seen from China
seen from Malaysia
seen from Poland
seen from Malaysia
seen from Ireland
seen from China
seen from United States
seen from United States
seen from China
seen from Slovakia
seen from Russia
seen from Slovakia
seen from United States
seen from China
Advent calendar! Not a lot of in progress pics because it went together so easy.
I like it so much! I really should colour my 3D models more, it's really helped the feeling that I've just reached into the monitor and plucked out the model.
Including reprints:
4.5kg of PLA
140+ hours print time
Dammit I pressed the poll button again
Do you know how to delete a poll on mobile?
Yes (tell me please)
No
Anyway, next up is to fill it, which may take a while.
Anya is live and ready to show you everything. Watch her strip, dance, and perform exclusive shows just for you. Interact in real-time and make your fantasies come true.
Free to watch β’ No registration required β’ HD streaming
Sigh, so this was going well... But then all 4 hinges snapped on the left hand piece
What I THINK happened is that was the first part I printed and the first layer on the roll of red filament had been out for a while so when it printed it was weak
More filament, try again
Slooow going
Messed up the hinged green boxes. So, if you print a hole vertically it's even more undersized than printing horizontally good to know. I managed to drill out half of the boxes but had to reprint 4 of them... Which meant I ran out of green again, two boxes left :(
BUT I can assemble the rest in the meantime I really hope the hinges work, it's going to be tight
On the bright side, the inlays look really cool
I have made myself a giant jigsaw puzzle, had to order more filament already and also printed some pieces back to front
But it's okay! Mostly
Part 1 done
Not sure I like the texture plate, they need to sell a plate that has the faint impression of layer lines so all the sides can match :P
Otherwise, that support material? Mwah, beautiful comes off so clean and easy there's no other way I would be getting that 1mm recess on the back
There's a couple of weird artifacts, but they'll clean up or be hidden
Print time: 15h 23m
Anya is live and ready to show you everything. Watch her strip, dance, and perform exclusive shows just for you. Interact in real-time and make your fantasies come true.
Free to watch β’ No registration required β’ HD streaming
woo hoo fully modelled, waiting for plastic to get here and then we shall be printing for days on end
Latch test
1. Misread a number, didn't realise til I tried to attach
2. Too loose, yet still hard to open
3. Width is right now, kinda impossible to open
Gave up at this point and went to bed. In the morning I remembered I'd printed an enclosure with this type of latch and went to get tips
4. Fully open on the hinge side, reversed cutouts on the latch end. Not enough flex on the latch end too loose on the hinge, arms too long and catching on the box
5. Bit tight on the hingeside, but I'll take it, nice firm snap on the latch, no movement once closed. We have a winner.
Slowly learning what clearances and flex works for my printer, going to be using a filament hinge for everything now, it's just easier.
The Plan
I'm liking this much better than my first attempts, not sure about the white numbers, might go with red.
The base model, all other parts will be made with mirroring
wait I need a latch... ehhh more thought required
