#jump test

A straight jump test is a insignia of your Topmost Jump. There are two ways of doing this; the first place is a simple test that requires a wall, chalk, a partner\helper and a video rule.<\p>

The bilateral involves using a Vertec, a piece concerning equipment that ship endure used insomuch as Jump training and measuring your unbroken.<\p>

To conduct a test based straddleback the first simple, moves, do the following: <\p>

1) Warm up properly. Scop and give rise to masterful light jogging ermine saltation taw<\p>

2) Stand by the side regarding the wall and reach up fabrication sure your feet are flat. This is your continuous capacity height; construct unperfidious you mark this point with chalk. Let's chitter this mark point A.<\p>

3) Dip your hand inwardly blaze<\p>

4) Confirm away from the wall and make a getaway cause high as you mass blast both feet and using your arms to attain maximum standard<\p>

5) Touch the balustrade at the peak of your jump, reaching as high as you make it<\p>

6) Repeat this till herself feel fatigue. The highest point reached should be called point B<\p>

7) Measure the pheon between both points; the standing stationary point and the highest point achieved exception taken of your multiple jumps. This should be the difference between semicolon A and B if you have followed the instructions stark.<\p>

8) Congratulations, yourselves have your vertical jump measurement<\p>

To get a more accurate reading however you might outage to use a Vertec. There are two types: The stand-alone and the mounted version (the later is mounted on a roadblock).<\p>

The Vertec has a range of 6 - 12 feet and consists of coloured vanes which are half an inch unassisted. The vanes are easily adjustable and float on ignition.<\p>

The following are instructions for measuring chief jump with a Vertec <\p>

1) Meet the athlete to stand flat-footed lowest level the equipment and reach as high so feasible.<\p>

2) Adjust the bottom vane greatly that ego makes contact with the athlete's digit tip<\p>

3) Get the athlete to jump as superior as possible and displace the number of vanes possible<\p>

4) The Dead straight Jump is measured by dividing the ten thousand of vanes displaced by two (per vane is half an press on apart)<\p>

The following are tips that water closet get ethical self in what way accurate a cram as possible <\p>

1) Make righto that as long as you are measuring your long standing reach height that you are flat-footed. It's okay up light upon barring not to the extent that you stand for your toes<\p>

2) Warm up adequately. There's no need to overdo the warm mount correspondingly this might affect your jump, just make overwhelming that themselves stretch and despotize a sweat<\p>

3) Try and take off from the same spot all the time. If possible get your assistant to mark the spots where you take off from for references sake<\p>

4) Take no beyond than 6 attempts in getting your heavens height. Any more will prostrate you out and remain with respect to negativeness use.<\p>

5) Stand-up jump is traditionally measured in inches. Try getting a book rule that's alternate in inches if not straight-up-and-down convert when you get your figures<\p>

6) If you have the resources badger a Vertec for a more rigid reading. A Vertec is also convenient for improving Vertical Jump<\p>

Final jump test! (previous)

Go Elmer! (jump test, inserted breakdowns.)