May 24, 2020
#grizzlymill #grizzlymillingmachine #manualmill #evaderknives #dailygrind #handmade https://www.instagram.com/p/CAjaFkJjOud/?igshid=efnhe4kbuom5
Loading...
seen from United States
seen from Netherlands
seen from Malta
seen from China
seen from Poland
seen from United States
seen from Bulgaria
seen from China
seen from United Kingdom
seen from Uruguay
seen from Algeria
seen from Germany
seen from Chile
seen from United States
seen from Germany
seen from Singapore
seen from China
seen from Mexico
seen from China
seen from United States
#grizzlymill #grizzlymillingmachine #manualmill #evaderknives #dailygrind #handmade https://www.instagram.com/p/CAjaFkJjOud/?igshid=efnhe4kbuom5
Anya is live and ready to show you everything. Watch her strip, dance, and perform exclusive shows just for you. Interact in real-time and make your fantasies come true.
Free to watch • No registration required • HD streaming
Cleaning up the mill & crashing for the night... #millingmachine #grizzlymill #knifemaker #evaderknives (at Fairfax County, Virginia) https://www.instagram.com/p/ByMEdPgniEG/?igshid=xnr9bypmp1gz
Another corner of the #workshop cleaned... #shoplife #knifemaker #evaderknives #grizzlymill #grizzlylathe (at Fairfax County, Virginia) https://www.instagram.com/p/BswyKHDBH_U/?utm_source=ig_tumblr_share&igshid=1xim07r1cfccf
The stops are done for the #grizzlymill. I used the knob off the extra handle for more control. #EvaderKnives #machiningnoob #machining #powerfeed #knifemaker (at Vienna, Virginia)
I fought this #power feed tooth & nail, but FINALLY!!!! It WORKS!!! I must say stacking 2x4 and using a ruler to level is one of those fine line between madness/genius, but that also worked great!!! Now I just have to install the stop. #EvaderKnives #machining #machiningnoob #grizzlymill (at Vienna, Virginia)
Anya is live and ready to show you everything. Watch her strip, dance, and perform exclusive shows just for you. Interact in real-time and make your fantasies come true.
Free to watch • No registration required • HD streaming
I fought this #power feed tooth &a nail, but FINALLY!!!! It WORKS!!! Now I just have to install the stop. #EvaderKnives #machining #machiningnoob #grizzlymill (at Vienna, Virginia)
I'll tell ya what this little bearing cover on the #milltable is fighting every bit of the way. I did figure out, if you use the hex bolts off of the #power feed panel(basically any of the small #grizzly silver Allen screws, they are on everything ) & screw them into the pins holding the end pieces, the pin comes right out. So close yet so far. #EvaderKnives #knifemaker #machiningnoob #grizzlymill
So I figured while I was at it, I would cut out some protection for my #grizzlymill table. It'll also make cleaning up easier. #Carpentry #knifemaker #EvaderKnives (at Vienna, Virginia)