#dmodelling

This paper deals with Go kart chassis building with the help of modelling software CATIA V15 and analysis of the same for front, side and rear impact. The cassis has been designed for light weight profile and engine mounting of capacity 135cc. The go kart vehicle is meant for participation in various Go kart event organized all over the India. The preliminary test for these events is checking of 3 D model of the chassis frame and analysis of the same chassis frame under front, side and rear impact. During collision the chassis is under impact loading conditions so it has to be thoroughly analyzed for impact loads. The studies found below shades some light on how the chassis behaves under impact loading conditions. Chassis is made up of a tubular cross section pipe, fabricated assembly of EN8 grade and a few other grades. In this kart, we have used EN8 class tube with 1 inch diameter and 1.5 mm wall thickness. The results obtained for permissible stresses, Factor of safety and deformation are found to be well within range. This makes the chassis suitable for Go kart events. The main criteria that has been focused here is maximum deformation and stress. The stresses should be well within Von mises stress range and so as the Factor of safety. After analysis, both are found to be well within range.