Best Chemical Earthing & Lightning Arresters in Noida are provided by True Power under one roof including all World Class Earthing Electrode
What is Chemical Earthing and why should one Switch-Over to it soon
The wisdom lies in turning to Chemical Earthing soon without fail.
What is Chemical Earthing all about —
Chemical Earthing uses advanced chemicals such as Silica, Bentonite, Marcontile, etc., as Back Fill Compound to keep the soil resistance around the Earthing Electrodes minimum at all times from Peak summers to extrem-dry environmental conditions and in all areas from Stony dry lands to High range mountains, hilltops, etc. and that too without any addition of water or chemicals after the installation of chemical earthing.
Chemical Earthing provides any type of earthing resistance from 0.2 Ohms to less than 5 ohms, depending upon one’s requirement. For critical applications, 0.2 Ohms is usually desirable, whereas less than 5 ohms is good for general applications, while less than 10 Ohms is good enough for remote applications.
Chemical Earthing is installed in compliance with IS3043–1987 and IEC
60364. It is done using different types of Earthing Electrodes (discussed in the end) and advanced Back Fill Compounds depending on the type of soils and the desired earthing resistance requirements. It is the best fit for all different type of climates and environments.
How Chemical Earthing is Done —
Chemical Earthing requires the installation of an earthing electrode in the ground after digging a 1 to 3 meters hole of 4–5 inches dia. The earthing pit, is then filled and packed with the advanced Back Fill Compound. The Back Fill Compound can be added to the dug hole pit in the form of slurry or is added dry and then watered to make it stick around the earthing electrode to hold it tightly from all sides. The installed Earthing Electrode is then connected to the application/load by GI or Copper Strip. The GI or Earthing Strip connects the Earthing Electrode Terminal emerging out of the ground on its top to the load/application.
Why one should switch over to Chemical Earthing-
1) Conventional Earthing is no more effective: Conventional Earthing is no more effective for the type of Electrical appliances and products we are using nowadays. The type of low-resistance earthing in demand nowadays can not be met by using charcoal and salt as chemicals.
2) Low Service Life: Conventional Earthing has a life span of just 3–4 years when compared to the longer service life of 10–15 years of chemical earthing. This results in installing earthing after every 3–4 years of its installation. This not only leads to additional costs every time but also leads to the wastage of time and effort.
3) Unstable and Erratic Earthing Resistance:Â Conventional Earthing provides an unstable earthing resistance which varies regularly with every change in the environmental and climatic conditions. On the other hand, chemical earthing provides a stable and low earthing resistance throughout its life.
4) Life-long headache of adding water and chemicals: Conventional Earthing regularly requires pouring water and adding charcoal to the earthing pit to keep earthing resistance under control, whereas chemical earthing is of install and forget type. There’s no requirment for adding any chemical or water in Chemical Earthing, and it is perfectly maintenance free.
5) Spoils Water Table and pH of the Soil:Â Conventional Earthing not only spoils the water table under the ground, but also makes the surrounding soli corrosive and spoils its pH value. The corroded soil corrodes the earthing electrode or earthing plate inside the ground.
Contact us:
Call us:Â 8318455691
Email us:Â [email protected]
Address:Â D 242, Sector 63 Rd, D Block, Sector 63, Noida, Uttar Pradesh 201301
For more information visit:Â https://www.truepowergroup.in/true-power-noida.html
True Power Earthings Private Limited
