#busta13

I got this @powerhobby_com 35t motor going in #busta13. I have heard good things from others about these motors, so we going to give her hell this weekend. #powerhobbies #radiocontrolledeastcoast #vermontscalerc #vermontexpeditionseries

Well, with all my chores done, and cleaned up, I now get to start finishing up #busta13 for this weekends get together. 1st on the agenda is a transmission rebuild. Going to add some @boom_racing metal gears, refresh in bearings from boom as well. Then we'll see what's next. #boomracing #radiocontrolledeastcoast #vermontscalerc

Oh yeah! #busta13 is coming back from the dead now! More work to be done, but it's coming along nicely! These @pitbullxrc XOR's look killer, and the @cnccustomwheels add the bling factor to this D3 Build for the @ultimate_scale_challenge!! #shredtheledge #radiocontrolledeastcoast #vermontscalerc #ultimatescalechallenge

Still getting lights hooked-up, and figured out. This bar is the perfect hight and protection for these swivel lights. I will be sure to have illumination next weekend for sure! #powershiftrc #differentonpurpose #busta13 #radiocontrolledeastcoast #vermontscalerc

Well looky here!! I snagged some @powershift_rc_technologies brake lights while visiting him in ND. As luck would have it, the small brake pods fit right inside of the pre-drilled holes for other brake lights I assume. So, when I get time I'll drill out the holes for the bolts and get these set up! #powershiftrc #busta13 #brakesyo #differentonpurpose

Getting these @cnccustomwheels wrapped around these new @pitbullxrc XOR 1.9's. This combo will be all up on #busta13 by the end of the day. I'll try and get something accomplished done so I can wheel at next weekend's Camel Hump over night run. #pitbulltires #cnccustomwheels

For #busta13 I decided to throw in a @powershift_rc_technologies servo winch. I put it right up front next to the steering servo. It's a little high, so I will lower it down to clear the hood. Went on fairly easy, and should do just the trick for yanking duties! #USCV_DE3 #shredtheledge #radiocontrolledeastcoast #vermontscalerc #ultimatescalechallenge

There, that already looks 100 times better in my eyes. Lower, straighter, and looking tougher already. I'm loving it so far. Done working on this for now, but have more to do in the coming weeks. #busta13 is on it's way to a solid Division 3 Extreme @ultimate_scale_challenge build. Up next is servo winch mount, transmission rebuild, electronics and some more scale equipment. #ultimatescalechallenge #vermontscalerc #radiocontrolledeastcoast #shredtheledge #USCV_DE3