#ar15 built

Since I’m single with no real expensive bills like car payments its time to turn this rifle, my BCM Mid-length which is my go to rifle, my “bug out” rifle, my main training gun from mostly stock to “ ripping the knob off at 11″ 

Spending money for diminishing returns is not something I endorse but, what the hell. 

First off is replacing my Griffin Armament M4SDII comp for this VG6 Gamma Brake. 

Then its an VLTOR A5 buffer system without...any VLTOR parts except the buffer. 

V7 2055 Aluminum/Lithium A5 buffer tube: The A5 length with the enhancements of the PWS buffer tube at the same weight as a standard mil-spec tube. (lightening cuts, drain holes, extension for carrier tilt)

PWS ratcheting castle nut

Springco Green rifle spring 

VLTOR H2A5 buffer

V7 Titanium buffer detent spring

Moving on to the lower receiver:

Battle Arms Development Enhanced Titanium Take-down/Pivot pins

V7 Titanium grip screw

V7 Titanium trigger pins

V7 S7 Diamond bolt catch 

V7 Diamond Titanium magazine release button

BCM gunfighter grip mod 1 with Talon grip tape

Elfftmann push button ambidextrous speed safety

Moving onto the upper receiver:

V7 Diamond Titanium forward assist  

Battle Arms Development Enhanced Nitride BCG

V7 Titanium Cam pin

V7 Titanium firing pin 

KNS Perma pin

Scalarworks LDM Aimpoint PRO optic mount

If i was so inclined I would add in a V7 titanium port door kit and a Lantac nitride gas tube but thats just too much work to warrant them with having to take the barrel/barrel nut off and all that.