Early 911 and 912 heater slide vent block off caps. I made these one-off caps to cover the floor well heater slide vents since they weren’t being used. This specific car is a 911R tribute with no interior so a simple design worked out. They mount in similar fashion to torsion bar covers. Took measurements and made a template. Cut out a hammer form and shaped 3003 .063” aluminum over it. Prior to that I annealed it and kept the heat on longer by accident but it ended up creating a neat cast texture. I ended up liking the look so I left it. Used a die I made years ago to Finish off the mount bolt. Made the nut plates out of steel for strength and used an aluminum torx bolt which I believe came off of a GT3. Had fun with these. There’s something about making parts from scratch and by hand. #sleepersspeedshop #porsche911 #hammerform #early911 #911rtribute (at Sleepers Speed Shop) https://www.instagram.com/p/CqzLby7Lq0P/?igshid=NGJjMDIxMWI=







