#pantoffel

The saddle is real leatherwork at a tiny scale. Everything patterned, wet-shaped, dyed, finished, and assembled by yours truly. The saddle blanket is custom-made to match as well. The seat of the saddle is stitched to the base just at the front and back to allow the pieces to move in relation to each other for a more comfortable fit.

The pommel and backrest are both modeled and 3D printed by yours truly as well, with sports tape for the fabric on the pommel. Both are attached using rivet backings set through hollow points in the prints.

From the back more detail can be seen for the backrest. It is wet-shaped and stretched over the base, and then flathead pins were cut short and turned into the tiniest nails to nail it in place. No glue was used at all in it's construction.

The collar was constructed so that it fit around Sharky's head and then the tension in the straps under his legs pulled it tight. Those straps are attached to loops placed in the stitching with lobster clasps. Much of the construction is hidden in his majestic chest fluff, but a good chunk of it can be seen here.

And now on to his co-star, Captain Emil Toma!

This was a Finn action figure that I did heavy modifications to. Original details were mostly sanded off for a vaguely person-shaped base thar I then sculpted details back onto with epoxy-putty. Even his face recieved a bit of shaping to change the underlying bone structure to match Emil better. All of the original joints still move save for his left wrist, which needed to be sealed in place lest his hand fall off. The gun the figure was holding was replaced by his sword. I decided to stick to mostly early/mid-comic designs, picturing this as a toy a Crescean kid might play with before the events of the comic take place.

From the back we can see the leather pouch which was hand-stitched together and attached with a rivet back. It's fully functional and can store approximately 4 quarters in it. The scabbard was 3D printed with a peg for attachment purposes and the parts that 'hold' it to the sash are clothing tags.

The sash itself is fabric and held in place with fashion tape. Edges were melted to seal them and then folded under to allow me more control over how they wrinkle. The badge is hand-sculpted from the same epoxy-putty used to modify the body. It's about as tall as my thumbnail and I have never wished for a resin printer more ardently than when I was sculpting it with a straight pin.

Proportionally the two of them are nearly perfect together! But, regrettably, the figure was too heavy to sit in the saddle on his own. Especially on a dog that can out-run a dalmatian! Hence why they were photoshopped together for the final image.

I hope you enjoyed this tour of the utter insanity that has been my free time for the last few months. I actually started this before the contest was announced...and through some setbacks and bad timing of life events still didn't get done until the last minute. As promised, here is your special treat!