#murrayclarkmuzz64

The Smart Stand is a holder / stand for use with modern smart devices. The stand comes in a phone or tablet version and was designed to enable users to hold their device on a specific angle for video calls and staged photos in particular... but it's also a great little stand for general use. Most other phones/tablet stands have a fixed angle or, if they can be adjusted, are limited to a number of angles that may or may not be just right for the video or photo needs at the time. The basic concept of this design is that it should hold any phone or tablet and be angle adjustable from nearly vertical (-5°) to tilted way back and close to horizontal (i.e. at an unusable angle for photos and video / -70°). Although the number of devices this has been tested on is limited, the files posted should work in this way for most phones and tablets. The holder should accommodate and function well with any phone or tablet up to 15mm thick. Just drop the phone or tablet into the holder, tilt back with the nut and bolt loosened to some extent then tighten at the desired angle... very simple. Read the full article

The Car Headrest Bag Hooks design is similar to some commercially available... but unlike other designs, this is made in a way that this cannot be accidentally detached/unhooked from the heat rest posts due to the way it assembles. Headrest Bag Hooks are a great solution for your own use but will also be appreciated by many people as a practical gift for everyday use. Before starting you will need to measure your car's headrest seat posts to decide which Bracket and Spacer to download and print. Most cars will use the (up to) 15mm. Assembly and fitting are easy, as follows: (1) Raise the headrest in your car so the U shaped Bracket can be pushed onto one of your headrest posts (2) Insert the Spacer to close off the open end of the Bracket (3) Slide the Centre section through the Bracket and Spacer until it is centered (protrudes out of the Bracket equally on each side). You will need to align the flat surface of the Centre section with the flat surfaces inside the holes in the Bracket. (4) Slide two Hooks onto the assemble (one on each side) (5) Screw one Bolt into each end of the Centre section and tighten. (6) Make sure the hooks can still swing freely and individually in the Centre section. (7) Lowering the headrest is suggested as this will reduce how much the assembly can move around in use. (8) Place one or two bags onto the Hooks as required... Read the full article